Official Baja SAE Forums Homepage
Forum Home Forum Home > General > Design Discussion
  New Posts New Posts RSS Feed - Seat Mounting
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Seat Mounting

 Post Reply Post Reply
Author
Message
AgentP View Drop Down
Double Secret Probation
Double Secret Probation
Avatar

Joined: Jun/27/2017
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote AgentP Quote  Post ReplyReply Direct Link To This Post Topic: Seat Mounting
    Posted: Dec/31/2018 at 4:52pm
https://imgur.com/VVJ2jOv
In the image there are 3 tubes attached across LFS with holes drilled for seat mounting. The holes are drilled on a square cross section tube of dimensions 20x20x2 mm. So, I wanted to know if using a rod of thickness 2mm instead of a tab of 2.3 mm thickness is allowed or not. If yes, do I need to use a sleeve for a square rod as per rule for drilled members. Also is it allowed to keep holes beyond 1in distance from weld in this case.?
Though the arrangement does not exactly follow the rules, the arrangement is still quite sturdy since the seat now has a support of 4 members including the USM
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.172 seconds.