Hey Everyone!
Here are the rules for the event regarding your vehicles! Let me know if you have any questions!
The event will start Saturday morning (11/11/17), with the endurance race starting around 1:00pm and ending when the sun sets. If there are enough Night Race participants, it will run for one hour, starting shortly after endurance ends. All rules mentioned below will be regulated by race officials, who will have final say over all decisions.
Main Design Regulations Frames must follow BAJA SAE official design rules of 2010 and newer. o We will accept tech-inspection stickers on vehicles 2016 or newer, please bring verification for older vehicles Towing points are needed on front and rear of the car Any indents compromising the frame will be judged by an inspector who has final decision on repairs All vehicles need to have complete body panel coverage on the outside of the car from the regulations of SAE rules All frame joints need to have a complete/finished weld with no edges showing on weld attach points
Engine Regulations: SAE Class Unmodified, four-cycle, air cooled, Briggs & Stratton 10 HP Vanguard or Intek Models No engine modifications are allowed in this event o No modified exhaust o Fuel tank ID number: 799863 o Governor set to 3,800 rpm (nothing faster) Hybrid engine designs are not allowed along with no electric boasting components We suggest a fuel spill pan or some kind of drainage system or miss spilled fuel, but it is not required
Engine Regulations: Superclass Four-cycle, air cooled, Briggs & Stratton 10 HP Vanguard or Intek Models All modifications have to reported to tech inspectors, with all decisions left to inspector
Night Race Regulations Headlights with separate power source for continuous power with killed engine Retroreflective tape must be attached to the Side Impact Member, Front Bracing Member,and the Aft Bracing Member to insure visibility. Only SAE Class vehicles are permitted
Electrical Set Up Two kill switches o First needs to be in easy reach of the driver o Second kill switch at rear top corner of the back end of the vehicle o Both kill switches need to connected to the motor and either one will kill the engine immediately One brake light o Needs to have power entire race if powered by secondary source Any secondary power sources need to be factory made and not personally made All wires need to be sealed with no loose connections
Safety Requirements Required racing gear is found in the BAJA SAE rules under “Driver equipment” of 2017 year regulations o Helmets must to be Snell SA 2010 or newer with no serious damage to the outer edge of the helmet o Wrist restraints are required Refueling requires the engine to be turned off and driver out of car Fire extinguisher is required in every vehicle registered for the race, and one is required to be in hand when refueling or working on the vehicle All work requiring a tool must be performed in the pit area
------------- Geoff Angle 10 Cup Racing
|