Print Page | Close Window

power train

Printed From: Official Baja SAE Forums
Category: General
Forum Name: Pit of Despair
Forum Description: Don't even think about trying to escape
Printed Date: Dec/08/2021 at 7:18pm

Topic: power train
Posted By: vehicle dynamics
Subject: power train
Date Posted: May/30/2014 at 10:07am
Please tell gear ratio of mahindra alpha euro3....i shall be highly obliged:-)

Posted By: arry
Date Posted: May/30/2014 at 3:12pm

Posted By: Rudolf Ragis
Date Posted: Mar/15/2017 at 8:39am
I need some info on axle joints. Universal , CV Specifically rzeppa , and wht to consider while designing to reduce weight 

Posted By: sujandinesh
Date Posted: Mar/15/2017 at 11:54am
Google - They are mainly used in front wheel drive vehicles, and many modern rear wheel drive cars with independent rear suspension typically use CV joints at the ends of the rear axle half shafts and increasingly use them on the prop shafts (drive shafts).
Wikipedia - Constant-velocity joints (AKA homo-kinetic or CV joints) allow a" rel="nofollow - drive shaft  to transmit power through a variable angle, at constant rotational speed, without an appreciable increase in friction or" rel="nofollow - play . They are mainly used in" rel="nofollow - front wheel drive  vehicles, and many modern" rel="nofollow - rear wheel drive" rel="nofollow - cars  with" rel="nofollow - independent rear suspension  typically use CV joints at the ends of the rear axle half shafts and increasingly use them on the prop shafts (" rel="nofollow - drive shafts ).

Consider weight while designing to reduce it. 

I mean jokes apart, but you need to be more specific in your questions if you are expecting a proper reply! 

RVCE BAJA: 2011-2015
General Motors: 2015-2016
Tyre Testing - University Racing Eindhoven: 2016-2017
Tyre Dynamics - TASS International: 2017-2018

Tyre Engineer - Apollo Vredestein
The Netherlands

Posted By: RLM
Date Posted: Mar/15/2017 at 3:12pm
Rudolf, please see mid-term exam below:
Section 1: Short answer.
1) your question has nothing to do with the original post, so why dig up this ~3 year old thread? please explain. (2 pts)

Section 2: Essay Response, min of 1 intro, 3 body, 1 conclusion paragraphs.
2) what information are you looking for and what have you already obtained? ( 10 pts)

Section 3: Multiple Choice.
3) what have you already considered in terms of reducing weight? (please select all that apply. 15 pts)

a) size
b) theoretical max torque
c) measured max torque
d) max rotational speed
e) material
f) heat treatment
g) designed life expectancy
h) lubrication
i) abnormal loads
j) manufacturing tolerances required
k) manufacturing tolerances that can be done
l) shaft balance
m) non rotational loads
n) to plunge or  not to plunge
o) other _________________________________________________________

McMaster Baja Racing (09-Dec 2015)
Team Captain 2012-2015
Suspension Lead 2015-2016
All spoonfeed PM requests will be billed at $10 USD per reply, payable via paypal.

Print Page | Close Window