Official Baja SAE Forums Homepage
Forum Home Forum Home > General > Design Discussion
  New Posts New Posts RSS Feed - Members Deformation
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Members Deformation

 Post Reply Post Reply
Author
Message
Eduardo Gutierrez View Drop Down
Double Secret Probation
Double Secret Probation


Joined: Jan/29/2020
Location: Mexico
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote Eduardo Gutierrez Quote  Post ReplyReply Direct Link To This Post Topic: Members Deformation
    Posted: Jan/29/2020 at 4:36pm
Hello, due to complications of making the bends of the members, we've got unwanted deformations and the doubt is if putting a gusset on the members will regulate according to rule B.3.2.12.1. Here are the link for the photos of how the deformations remain 
https://drive.google.com/open?id=1FsoHwGlQ7hLq6hZ5G-rPuN7fPhkuUBum


Edited by Eduardo Gutierrez - Jan/29/2020 at 4:49pm
Back to Top
zxb View Drop Down
Double Secret Probation
Double Secret Probation


Joined: Feb/08/2020
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote zxb Quote  Post ReplyReply Direct Link To This Post Posted: Feb/08/2020 at 10:56pm
I don't think that would work. Where is that bend located in your chassis?
Back to Top
Eduardo Gutierrez View Drop Down
Double Secret Probation
Double Secret Probation


Joined: Jan/29/2020
Location: Mexico
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote Eduardo Gutierrez Quote  Post ReplyReply Direct Link To This Post Posted: Feb/10/2020 at 3:00pm
The bends are from the roll hoop and the largest tubes from the chassis, it goes form FMBup and ROH both members

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.031 seconds.