Official Baja SAE Forums Homepage
Forum Home Forum Home > General > Design Discussion > Pit of Despair
  New Posts New Posts RSS Feed - material for knuckle
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic Closedmaterial for knuckle

 Post Reply Post Reply
Author
Message
alok View Drop Down
Bolt Sorter
Bolt Sorter


Joined: Aug/27/2013
Location: bangalore
Status: Offline
Points: 6
Direct Link To This Post Topic: material for knuckle
    Posted: Oct/08/2013 at 3:43am
we are planning to use aluminium 6061t6 to manufacture our knuckle. is the material safe ?????
can any other steel alloy be used??????
Back to Top
joey.m.gonzalez View Drop Down
Welding Master
Welding Master


Joined: May/09/2013
Location: San Diego, CA
Status: Offline
Points: 132
Direct Link To This Post Posted: Oct/08/2013 at 3:59am
theres a thread literally 2 down from yours asking the same question

http://forums.bajasae.net/forum/material-for-upright_topic1315.html

please, SEARCH... or at the very least look for more than 5 seconds before posting...
Back to Top
Mod Squad View Drop Down
Welding Master
Welding Master
Avatar
Mutant Enforcer

Joined: Oct/19/2010
Status: Offline
Points: 200
Direct Link To This Post Posted: Oct/08/2013 at 5:48pm
Locked due to stupidity.
 
Anyone know the range of IP addresses India uses? AngryNuke
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.061 seconds.