Official Baja SAE Forums Homepage
Forum Home Forum Home > General > Design Discussion
  New Posts New Posts RSS Feed - LDB - Lateral Diagonal Bracing
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

LDB - Lateral Diagonal Bracing

 Post Reply Post Reply
Author
Message
Magno View Drop Down
Double Secret Probation
Double Secret Probation


Joined: Sep/04/2018
Location: Brazil
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Magno Quote  Post ReplyReply Direct Link To This Post Topic: LDB - Lateral Diagonal Bracing
    Posted: Sep/04/2018 at 12:02pm

Hello,

I have a doubt regarding the rule B.3.2.7 - LDB – Lateral Diagonal Bracing.

To meet team’s goals for chassis, we opted to make the Lateral Diagonal Bracing as showed in the picture which address is attached below. This configuration is previewed and considered acceptable by the brazilian’s regulation, however there is nothing on the american regulation that approves or desapproves this kind of bracing.

https://imgur.com/19zI3T2

As seen on the rule, the LDB designed by the team, extend from one RRH vertical member to the other, top and bottom intersection between LDB and RRH vertical members are less  than  5in from points A and B and the angle between the LDB and the RRH vertical members are greater than 20 deg.

Thereby, I wonder if this configuration would also be valid on a competition organized by SAE International.

Best regards,

Magno Santos.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.047 seconds.