Recorded Specs at Auburn |
Post Reply |
Author | |
Andy.R
Welding Master Joined: Dec/02/2014 Location: Ames, IA Status: Offline Points: 150 |
Post Options
Thanks(0)
Posted: Jun/16/2015 at 11:03am |
Before going through design presentation, every vehicle was weighed and measured(track width and wheelbase). I was wondering if these sets of information where available. I checked the results and did not see any notion of them. It would be interesting to see the variation of front to rear track widths in a few of the cars along with some extremes. |
|
jarmumd
Organizer Joined: Oct/17/2008 Location: Huntsville, AL Status: Offline Points: 178 |
Post Options
Thanks(0)
|
Thanks for reminding us! Were working on it!
|
|
Auburn Baja 03-05
Masters involving dynamic simulation of baja car and driver SAE Auburn Race Organizer 06, 09, 12, 15 SAE Birmingham Race Organizer 11 National Tech. Inspector 07-15 |
|
Andy.R
Welding Master Joined: Dec/02/2014 Location: Ames, IA Status: Offline Points: 150 |
Post Options
Thanks(0)
|
Thanks for the update! Auburn 2015 was very well organized and fluid
|
|
Andy.R
Welding Master Joined: Dec/02/2014 Location: Ames, IA Status: Offline Points: 150 |
Post Options
Thanks(0)
|
Not sure where my friend found it, but here are the specs of every car before design presentation at Auburn. |
|
JeremyB
Organizer Last one standing Joined: Oct/13/2008 Location: Huntsville, AL Status: Offline Points: 135 |
Post Options
Thanks(0)
|
They've been uploaded to the main results page: http://students.sae.org/cds/bajasae/results/
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |