Official Baja SAE Forums Homepage
Forum Home Forum Home > General > Design Discussion
  New Posts New Posts RSS Feed - Bends in the RHO
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Bends in the RHO

 Post Reply Post Reply
Nickw114 View Drop Down
Double Secret Probation
Double Secret Probation

Joined: Sep/30/2019
Location: New York
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Nickw114 Quote  Post ReplyReply Direct Link To This Post Topic: Bends in the RHO
    Posted: Sep/30/2019 at 6:04pm
According to rule B.3.2.8 RHO "The forward ends of the RHO members (intersection with the CLC) define points CR and CL (Figure B-7). CLC, BLC and RHO members must all be coplanar and bends at the aft (rearward) ends of the RHO members are not permitted. When a bend is used at Point CR/CL or BR/BL these points are defined at the start of the bend on the top-most plane of the Roll Cage, shown in Figure B-11: Roll Cage, Template Installation. " there must be no bends towards the aft end of the RHO.  does this apply to bends at the midpoint of the member?  this bend is only in the horizontal direction and has no vertical change in elevation.


Edited by Nickw114 - Sep/30/2019 at 6:07pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

This page was generated in 0.046 seconds.